Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

4.9. The electric motor and a chain of the fan of a heater

THE GENERAL DATA

The scheme of an electric equipment of air-conditioning of salon

1. The battery 2. The main safety lock 3. An additional safety lock 4. The ignition switch 5. The heater relay 6. The electric motor 7. The resistor 8. The electric motor relay

9. The fan switch 10. The conditioner switch 11. To a rheostat 12. The gauge of pressure of the conditioner 13. Electromagnetic муфта 14. The amplifier 15. The thermoresistor 16. Отсечное the temperature relay

Arrangement of knots of a heater and the conditioner

1. A heater 2. The cooling block 3. The evaporator 4. The broad valve 5. The fan 6, 13. The electric motor 7. The electric motor air заслонки 8. The amplifier 9, 12. The fan resistor 10. The relay of switching of speed The fan 11. Отсечное the temperature relay 14. A back heater 15, 23. A radiator 16. The thermoresistor

17. The electric motor mixing заслонки 18. The relay of a back heater 19. The switch of a back heater 20. The control panel the conditioner 21. The amplifier of the electric motor mixing заслонки 22. The electric motor of a ventilating nozzle 24. The crane 25. The thermorelay 26. The pressure relay 27. Влагоотделитель 28. The condenser 29. The compressor

Socket of the electric motor of a heater and socket distributing

1. A socket of a forward heater of a series 80 2. A socket of a back heater of a series 80

The block blowing a heater is mounted under the forward panel, or in salon on cars with air-conditioning of a back part of salon.

Check

PERFORMANCE ORDER

The prevention At performance of works on a heater of a part of cars disconnect a safety pillow. For this purpose translate the ignition key in position LOCK, disconnect the battery from weight and start works not earlier than in 2 minutes 1. In default the fan check up a safety lock, a condition of contacts and wires and degree of a charge of the battery. 2. Check up presence of pressure from the battery on an electric motor socket (include ignition and translate the fan handle in position ON). 3. If pressure is not present, there is a wire breakage from the lock of ignition or from the switch. 4. If pressure is present, attach a socket and connect a mass conclusion to weight, having connected a crosspiece from the back party of a socket. 5. If the fan does not join, is possible that the electric motor is faulty. 6. In this case connect electric motor conclusions directly to the battery and weight the wires protected by safety locks. 7. If the electric motor does not join, it is necessary to replace it. 8. If the engine is serviceable, check up the resistor or the switch for what remove the control panel a heater (see subsection 4.11).

Replacement

PERFORMANCE ORDER

1. Disconnect a socket, remove a socket arm, turn away 3 screws and get the block blowing from a casing. 2. Крыльчатку it is possible to remove and establish on the new electric motor. 3. Installation is carried out upside-down.