Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
- 4. Systems of cooling, heating
   4.1. Technical characteristics
   4.2. Antifreeze
   4.3. The thermostat
   4.4. Крыльчатка the fan and гидромуфта
   4.5. A radiator and a broad tank
   4.6. Маслоохладитель
   4.7. The pump of system of cooling
   4.8. The gauge of temperature of a liquid
   4.9. The electric motor and a chain of the fan of a heater
   4.10. A heater radiator
   + 4.11. The control panel a heater and the conditioner
   4.12. A central air and heating
   4.13. Влагоотделитель the conditioner
   4.14. The conditioner compressor
   4.15. The condenser
   4.16. The evaporator and the broad valve
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

4.7. The pump of system of cooling

THE GENERAL DATA

The pump of a cooling liquid of the engine 3F-E

1. A perepusknoj hose
2. A hose маслоохладителя
3. A lining
4. The pump
5. A pulley flange
6. A drive belt
7. Гидромуфта
8. Крыльчатка
9. A pulley
10. An inlet hose
11. A pump plate
12. A heater hose

The pump of a cooling liquid of the engine 1FZ-FE

1. A lining
2. The pump
3. A pulley
4. A drive belt
5. An inlet hose
6. A casing
7. Крыльчатка
8. A perepusknoj hose
9. Гидромуфта

Check

PERFORMANCE ORDER

1. On the working heated-up engine cautiously press the top hose of a radiator and gradually release. At the serviceable pump in a hose the liquid pressure should be felt.

2. In the pump the control aperture for a liquid drain is provided. At failure of an epiploon of the pump through a control aperture the cooling liquid follows. To find this aperture, it is necessary to illuminate space behind a conducted flange of the pump, directly under shaft.

3. Deterioration of bearings can be defined, shaking the pump upwards and downwards, and on characteristic howl in a forward part of the engine.

4. The close sound on a tonality can publish and a sliping belt of a drive, therefore it is possible to draw an erroneous conclusion on malfunction of the pump.

5. To exclude a sound from a belt, put dispersion special structure for automobile belts.

Removal and installation

PERFORMANCE ORDER

1. Disconnect the battery from weight and merge cooling liquid (subsection 2.38 see).

2. Remove all belts of hinged units.

3. On cars till 1992 remove a roller натяжителя a belt of the conditioner and an arm, and also скобу generator fastenings.

4. Remove a casing of the fan and the fan (subsection 4.4 see).

5. Remove from the pump a pulley and disconnect hoses.

6. Turn away bolts (are specified by arrows) and remove the pump.

7. Disassemble the pump and replace linings.

8. Carefully clear a demountable plane of a cover of the lining rests.

9. Installation is carried out upside-down.

10. Bolts tighten with the set moment.