Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

4.16. The evaporator and the broad valve

THE GENERAL DATA

Evaporator fastening on cars of a series 60, 62


Evaporator fastening on автомобилх series 80

Details of the evaporator of cars of a series 60, 62

1. Wires 2. The relay муфты 3. The holder 4. The thermoresistor 5. The broad valve

6. A tube with a liquid coolant 7. The amplifier 8. The evaporator 9. Through a sealant 10. The relay of air-conditioning of a back part of salon

Details of the evaporator of cars of a series 80

1, 2, 6. A sealant 3. The broad valve 4. Through уплотнители 5. A drain hose 7. The resistor

8. The evaporator 9. The thermoresistor 10. Скоба 11. The amplifier 12. The otsechnoe relay

Removal and installation

PERFORMANCE ORDER

1. Depressurize the conditioner and remove a coolant car-care centre. 2. Remove перчаточный a box. 3. Disconnect conditioner tubes on a partition of a motor compartment. Turn on the union, keeping a key a reciprocal part not to curtail a tube. 4. On cars with the engine 1FZ-FE remove the processor block. 5. Turn away a nut and bolts of fastening and remove the evaporator. 6. Establish the evaporator on a table, turn away screws, remove latches, remove the top and bottom half of case of the evaporator and get the evaporator. 7. Get from the evaporator the thermoresistor, turn away bolts of fastening of the broad valve and two short tubes of giving and coolant tap (fig. Bolts of fastening of the condenser see). 8. Clear the evaporator a special comb and blow compressed air. 9. If the new evaporator enter nearby 40 г the fresh oil recommended for your conditioner is established. 10. Further installation is carried out upside-down. 11. Replace a sealing ring and linings of the broad valve. 12. Fill the conditioner with a coolant in the same workshop in which depressurization and coolant removal were carried out.