Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   - 3.4. An engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. The battery
      3.4.3. Power cables
      - 3.4.4. Ignition system
         3.4.4.1. Check of system of ignition
      3.4.5. The ignition coil
      3.4.6. The ignition distributor
      3.4.7. The block of electronic ignition
      3.4.8. The induction gauge
      + 3.4.9. System of a charge of the battery
      3.4.10. The generator
      3.4.11. Generator details
      3.4.12. System of start-up of the engine
      3.4.13. The starter electric motor
      3.4.14. The traction relay of a starter (а/м 1980-87 of release)
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


американские сигареты в Москве Форум 122d58df

3.4.4.1. Check of system of ignition
THE GENERAL DATA
The prevention

The ignition system develops very much a high voltage, therefore, at performance of works it is necessary to observe electrosecurity rules.

PERFORMANCE ORDER
1. If the engine is not started, and the starter turns коленвал disconnect high-voltage wires from candles and connect to them the calibrated rated sportsman, or disconnect a wire from one of candles, take away isolating tip and fix a wire on distance about 6 mm from the bared site of weight.
2. Turn коленвал a starter and watch a rated sportsman or a candle wire. There should be an intensive spark of blue colour.
3. If the spark is available, on candles necessary pressure moves (check up other wires to be convinced of serviceability of a cover of the distributor and бегунка). Turn out candles and check up.
4. If the spark is absent, or искрообразование unstable uncover the distributor and check up a condition of a cover and бегунка. At moisture detection wipe dry a cover and бегунок, establish a cover into place and repeat check.
5. If sparks on former are not present, disconnect from a distributor cover a high-voltage wire of the coil of ignition and connect a wire to a test rated sportsman or fix a coil wire on distance about 6 mm from weight.
6. If the spark has appeared, malfunction of a cover of the distributor, бегунка or wires can be the reason.
7. In the absence of a spark check up all conducting of a primary chain of the coil of ignition, be convinced of cleanliness and reliability of connections. Whether check up pressure on the coil from the ignition lock arrives. Check up the ignition coil (subsection 3.4.5 see) and the induction gauge of the distributor (subsection 3.4.8 see). Execute necessary repair and repeat test.
8. If the spark on the former is absent, replace a wire connecting the coil of ignition and a distributor cover (check up resistance of a wire and compare with standard). If replacement of a wire on obviously serviceable does not give result the electronic block of ignition is faulty.
9. Whether check up pressure from the battery on the electronic block moves at ignition inclusion. If pressure is absent, replace the electronic block.