Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   - 3.4. An engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. The battery
      3.4.3. Power cables
      + 3.4.4. Ignition system
      3.4.5. The ignition coil
      3.4.6. The ignition distributor
      3.4.7. The block of electronic ignition
      3.4.8. The induction gauge
      + 3.4.9. System of a charge of the battery
      3.4.10. The generator
      3.4.11. Generator details
      3.4.12. System of start-up of the engine
      3.4.13. The starter electric motor
      3.4.14. The traction relay of a starter (а/м 1980-87 of release)
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


122d58df

3.4.3. Power cables

Check and replacement

PERFORMANCE ORDER
1. Periodically check cables on all length, damage, растрескивание or the burn-out of isolation of cables, and also corrosion are not supposed. Unreliable connection of the battery can cause refusals at engine start-up, and also deterioration of operational qualities of the engine.
2. Check up a condition of connections of poles with plugs, presence on them corrosion, cracks and easing of fastening of wires. Presence of a white shelled touch under isolation in a plug place testifies to corrosion of conductors of a cable and necessity of its replacement.
3. Check up presence of corrosion and deformations on plugs and a condition of bolts of fastening.
4. Disconnect from the battery old cables, track packing of cables on their length and find places of their fastening to a starter and to weight, disconnect cables from the traction relay of a starter and weight. Remember a route on which the cable is laid to lay a new cable to the place of the replaced. Track, that after installation the cable has not been tense.
5. If cables are replaced new getting new cables, grasp with itself old. It is the extremely important, that new cables in accuracy corresponded to the old.
6. Clear carvings of fastening of cables of the battery on the traction relay of a starter and on a body, remove corrosion traces.