Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   - 3.4. An engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. The battery
      3.4.3. Power cables
      + 3.4.4. Ignition system
      3.4.5. The ignition coil
      3.4.6. The ignition distributor
      3.4.7. The block of electronic ignition
      3.4.8. The induction gauge
      + 3.4.9. System of a charge of the battery
      3.4.10. The generator
      3.4.11. Generator details
      3.4.12. System of start-up of the engine
      3.4.13. The starter electric motor
      3.4.14. The traction relay of a starter (а/м 1980-87 of release)
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

3.4.8. The induction gauge

THE GENERAL DATA

Backlash check between a rotor and a ledge of the induction gauge (1980-87)

1. The induction gauge

2. A backlash between a rotor and a ledge of the induction gauge

Backlash check in the induction gauge on cars 1988-92

1. Coil NE

2. Coil G

Backlash check in the induction gauge on cars since 1993

1. Coil NE 2. Coils G1 and G2

Check

PERFORMANCE ORDER

The prevention
On cars 1980-87 as the shaper of an initial signal the Hall gauge is used. Gauge check is carried out in car-care centre.

1. Disconnect a socket from the distributor and measure resistance between conclusions of the induction gauge.

2. Compare results of measurements to the values specified in subsection 3.4.1. If the measured resistance differ from standard values the gauge replace.

Backlash check between the gauge and a rotor

3. Disconnect the battery from weight.

4. Remove the distributor (subsection 3.4.6 see).

5. Brass probeом measure a backlash between a rotor and a ledge of the induction gauge (backlash Check between a rotor and a ledge of the induction gauge (1980-87), backlash Check in the induction gauge fig. see cars 1988-92 and backlash Check in the induction gauge on cars since 1993). If the backlash differs from standard on cars 1980-87 release screws and establish a backlash, on cars since 1988 replace the distributor as the backlash is not subject to adjustment (increase in a backlash against norm as a rule it is caused by deterioration of the plug of the distributor).

Replacement

PERFORMANCE ORDER

1. Disconnect the battery from weight.

2. Remove the distributor (subsection 3.4.6 see).

3. Turn away screws of fastening of the induction gauge (are specified by arrows).

4. Remove the induction gauge.

5. Installation is carried out upside-down. Adjust a backlash in the gauge.