Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Kinds of repair without engine dismantle
      3.1.3. Installation of the piston of 1st cylinder in ВМТ
      3.1.4. A cover of a head of cylinders
      3.1.5. A lateral cover of the mechanism timing
      3.1.6. Коромысла and bars of pushers
      3.1.7. Springs of valves, plates, маслосъемные caps
      3.1.8. Soaking up and final collectors
      3.1.9. A head of cylinders
      3.1.10. Pushers
      3.1.11. A pulley коленвала
      3.1.12. A forward epiploon коленвала
      3.1.13. A forward cover
      3.1.14. A cam-shaft and drive gear wheels
      3.1.15. A cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. The oil pallet
      3.1.18. The oil pump
      3.1.19. A flywheel (a leading disk of the hydrotransformer)
      3.1.20. A back epiploon коленвала
      3.1.21. Suspension bracket and engine details
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

3.1.6. Коромысла and bars of pushers
Removal

PERFORMANCE ORDER

1. Uncover heads of cylinders.

2. Release platen bolts коромысел in the specified sequence.

3. Remove the platen in gathering with коромыслами, without supposing соскальзывания details.

4. Get bars (drawing at the left) and store in an order of their former installation (a photo on the right).

Check

PERFORMANCE ORDER

1. Check up deterioration коромысел, especially in places of contact with bars and стрежнями valves.

2. Check up cleanliness of apertures коромысел in a place of contact with bars.

3. Check up presence of cracks, наволакивания metal and wear tracks about an aperture коромысла under the platen. Worn out коромысла replace.

4. Check up a condition of bars, presence of cracks and strong deterioration of end faces, check up наоprobeь deformation of bars, прокатив them on sheet glass.

Installation

PERFORMANCE ORDER

1. Oil the bottom end faces of bars for the engine or молибденовой greasing and establish bars on the places. The bar should enter into pusher deepening.

2. Grease молибденовой with greasing the top end faces of bars and cores of valves.

3. Establish platens with коромыслами and covers, screw hairpins of a cover of a head of cylinders. Tighten bolts in the specified sequence.

4. Establish all removed details, start the engine and hear to work клапанного the mechanism.