Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Kinds of repair without engine dismantle
      3.1.3. Installation of the piston of 1st cylinder in ВМТ
      3.1.4. A cover of a head of cylinders
      3.1.5. A lateral cover of the mechanism timing
      3.1.6. Коромысла and bars of pushers
      3.1.7. Springs of valves, plates, маслосъемные caps
      3.1.8. Soaking up and final collectors
      3.1.9. A head of cylinders
      3.1.10. Pushers
      3.1.11. A pulley коленвала
      3.1.12. A forward epiploon коленвала
      3.1.13. A forward cover
      3.1.14. A cam-shaft and drive gear wheels
      3.1.15. A cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. The oil pallet
      3.1.18. The oil pump
      3.1.19. A flywheel (a leading disk of the hydrotransformer)
      3.1.20. A back epiploon коленвала
      3.1.21. Suspension bracket and engine details
   + 3.2. The verhneklapannyj engine 1FZ-FE
   + 3.3. Dismantle and engine major repairs
   + 3.4. An engine electric equipment
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

3.1.11. A pulley коленвала
Removal

PERFORMANCE ORDER

1. Disconnect the battery from weight.

2. Designate and remove drive belts.

3. Lift car redock.

4. Turn away 6 bolts and remove a pulley of the pump of the hydraulic booster from a pulley коленвала.

5. Turn away a pulley bolt for what fix коленвал the adaptation. In the absence of the adaptation fix a flywheel (automatic transmission) or include transfer and a manual brake (manual transmission).

6. Remove a pulley a stripper.

Installation

PERFORMANCE ORDER

1. Replace a forward epiploon (subsection 3.1.12 see).

2. Grease a back part of a pulley молибденовой with greasing.

3. Dress a pulley, having combined a groove with шпонкой коленвала and easy blows of a hammer with soft brisk (or rotating a bolt) напрессуйте a pulley.

4. Tighten a bolt (nut) with the set moment.

5. Further assemblage is carried out upside-down.