Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and a steering
9.1. Technical characteristics
9.2. The stabilizer of a forward suspension bracket and the plug
9.3. Forward and back shock-absorbers
9.4. Springs and plugs
9.5. Springs of suspension brackets (а/м FJ80)
9.6. A cross-section bar (а/м FJ80)
9.7. Suspension bracket levers (а/м FJ80)
9.8. A rotary fist
9.9. A steering wheel
9.10. Steering draughts
9.11. A reducer
9.12. The hydraulic booster pump
9.13. Removal of air from the wheel hydraulic booster
9.14. Wheels and tyres
9.15. Corners of installation of forward wheels
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes
|
Details of a rotary fist
1. A lining
2. The plug
3. A pin
4. A nut
5. The lever
6. The bearing |
7. A cover of the case of an epiploon
8. A persistent ring of the case of an epiploon
9. A fist
10. A bolt
11. A bearing cover
12. A remote lining |
Removal
| PERFORMANCE ORDER |
| 1. Lift car redock. |
| 2. Disconnect from a fist steering draughts. |
| 3. Remove brake details. |
| 4. Remove полуось. |
|
5. Turn away bolts of the case of an epiploon. |
|
6. Turn away a nut of the lever and remove conic washers (are specified by arrows). |
|
7. Remove the top cover of bearings and a remote lining. |
| 8. Remove bearings and designate them ("right top", "right bottom" etc.). |
| 9. Remove the rests of old greasing from bearings, a plug and a fist, having washed out solvent. |
| 10. Check up a condition of bearings, presence on rollers of cracks, выкрашивания and wear tracks. Check up a condition of rings of bearings in plugs. The worn out bearings replace, having removed rings blows on brass оправке. Rings and holders of rollers vary in the complete set. |
|
Installation
| PERFORMANCE ORDER |
|
|
1. Put in holders of bearings refractory greasing, with force having pressed on the bearing so that greasing has come into holder separators. |
| 2. Apply a thin film greasings on the directing. |
| 3. Establish a new epiploon. |
| 4. Establish in a plug the top bearing, insert the bottom bearing. |
| 5. Keeping the bottom bearing, dress a fist on a plug of the bridge and establish a lining and the top cover. Wrap bolts. |
| 6. Establish the lever, conic washers, wrap nuts. Tighten nuts and bolts of covers of the top and bottom bearings with the set moment. |
|
7. Check up a preliminary tightness in bearings. If the moment differs from normal pick up a thickness of remote linings, having removed a part of linings or having established the new. |
The prevention The increase in a thickness of linings reduces a preliminary tightness in bearings, reduction of a thickness leads to tightness increase.
|
| 8. Further assemblage is carried out upside-down. |
|
|
|
