Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and a steering
9.1. Technical characteristics
9.2. The stabilizer of a forward suspension bracket and the plug
9.3. Forward and back shock-absorbers
9.4. Springs and plugs
9.5. Springs of suspension brackets (а/м FJ80)
9.6. A cross-section bar (а/м FJ80)
9.7. Suspension bracket levers (а/м FJ80)
9.8. A rotary fist
9.9. A steering wheel
9.10. Steering draughts
9.11. A reducer
9.12. The hydraulic booster pump
9.13. Removal of air from the wheel hydraulic booster
9.14. Wheels and tyres
9.15. Corners of installation of forward wheels
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes
|
The prevention Remove and establish each lever separately. If necessary to remove two and more levers remove springs and prop up the bridge a jack.
LEVERS OF THE FORWARD SUSPENSION BRACKET
Removal
| PERFORMANCE ORDER |
| 1. Lift car redock. |
| 2. Establish under the prop bridge. |
|
|
3. Turn away a bolt nut on a frame arm. |
|
4. Turn away a nut (are specified by arrows) on a bridge arm. |
| 5. Remove the lever. If necessary hook its mount. |
| 6. Check up a condition of plugs of the lever, presence on them of cracks, hardening and deformations. Replacement of plugs of levers is carried out in car-care centre as the special equipment is required. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down. |
| 2. Tighten all fastenings with the set moment. |
| 3. Bolts of fastening of the lever tighten under nominal loading of the car. |
|
LEVERS OF THE BACK SUSPENSION BRACKET
Removal
| PERFORMANCE ORDER |
| 1. Lift a back part of the car. |
| 2. Establish under the prop bridge. |
|
|
| 3. Turn away a nut of bolts (fastenings of the top lever on a frame arm (fig. on the right) and the bridge (a photo at the left are specified by arrows)). Remove the top lever. |
|
|
| 4. Turn away a nut of bolts of fastening of the bottom lever on a frame arm (fig. at the left) and the bridge (are specified by arrows in a photo on the right). Remove the bottom lever. |
| 5. Check up a condition of plugs of the lever, presence on them of cracks, hardening and deformations. Replacement of plugs of levers is carried out in car-care centre as the special equipment is required. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down. |
| 2. Tighten all fastenings with the set moment. |
| 3. Bolts of fastening of the lever tighten under nominal loading of the car. |
|
|
|
