Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. A mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. A distributing box
   - 7.4. Coupling, карданные shaft, semiaxes and leading bridges
      7.4.1. Technical characteristics
      + 7.4.2. Coupling
      + 7.4.3. Карданный () a shaft (), a reducer and axes
      7.4.4. A lobby полуось and an epiploon
      - 7.4.5. The back (forward) bridge
         7.4.5.1. A reducer epiploon
         7.4.5.2. Полуось, the bearing and an epiploon (semiunloading semiaxes)
         7.4.5.3. Полуось and an epiploon (completely unloaded semiaxes)
         7.4.5.4. A nave of a back wheel (completely unloaded semiaxes)
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

7.4.5.2. Полуось, the bearing and an epiploon (semiunloading semiaxes)

THE GENERAL DATA

Details of the back bridge with the semiunloaded semiaxis

1. A clip of a cable of a manual brake
2. A cable
3. A reducer cover
4. A lining
5. The bearing
6. An epiploon
7. A drum
8. A lining
9. Маслоотражатель
10. Полуось
11. A lock plate
12. The platen of satellites
13. The dividing plug
14. A pin

Semiaxes act in film for replacement of the bearing, an epiploon or removal of a reducer of the bridge.

Removal and installation

PERFORMANCE ORDER

1. Lift a back part of the car.

2. Remove wheels, disconnect a cable of a manual brake and remove drums.

3. Merge oil from a reducer.

4. Remove a back cover of a reducer.

5. Rotating reducer gear wheels, establish the platen in accessible position.

6. Turn away a bolt, get the platen and the dividing plug.

7. Ask the assistant to press on полуось and get from a semiaxis flute a lock plate.

8. Get полуось, keeping a canopy.

9. Check up a bearing and epiploon condition.

10. If it is necessary to replace them remove the bearing together with an epiploon a shock stripper with a two-maxillary nozzle.

11. Before semiaxis installation slightly grease epiploon edges консистентной with greasing.

12. Assemblage is carried out upside-down.

13. Tighten all fastenings with the set moment.

14. Fill in oil in a reducer.