Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. A mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. A distributing box
   - 7.4. Coupling, карданные shaft, semiaxes and leading bridges
      7.4.1. Technical characteristics
      + 7.4.2. Coupling
      + 7.4.3. Карданный () a shaft (), a reducer and axes
      7.4.4. A lobby полуось and an epiploon
      - 7.4.5. The back (forward) bridge
         7.4.5.1. A reducer epiploon
         7.4.5.2. Полуось, the bearing and an epiploon (semiunloading semiaxes)
         7.4.5.3. Полуось and an epiploon (completely unloaded semiaxes)
         7.4.5.4. A nave of a back wheel (completely unloaded semiaxes)
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


122d58df На сайте http://www.exponat-mebel.ru купить готовую кухню в Краснодаре.

7.4.5.1. A reducer epiploon
THE GENERAL DATA

Deterioration of an epiploon is found out in the wake of oil on a plug or a flange карданного the hinge. The epiploon varies without bridge removal.

Replacement

PERFORMANCE ORDER
1. Lift the car to hang out wheels.
2. Merge from a reducer oil.
3. Disconnect from a reducer карданный a shaft, take aside and fix.
4. Check up the resistance moment проворачивания wheels, rotating a reducer nut динамометрическим a key with a scale in some Н.м. This moment is equal to a preliminary tightness in bearings of a leading shaft of a reducer which should be created at assemblage.
5. Fix a flange of a reducer and turn away a nut of a leading gear wheel.
6. Designate nut and flange position.
7. By means of a stripper remove a flange of a leading gear wheel of a reducer.
8. Hammer blows displace an epiploon then hook and get an epiploon.
9. Grease epiploon edges консистентной with greasing and it is accurate запрессуйте a new epiploon.
10. Grease шлицы a shaft and a flange and establish a reducer flange, having combined labels.
11. Wrap a new nut, keeping a shaft from проворачивания.
12. Tighten with the minimum set moment specified in subsection 7.4.
13. Turn a reducer shaft on some turns.
14. Measure a twisting moment at which the leading gear wheel starts to be turned.
15. The demanded moment is equal to the preliminary tightness measured before dismantling plus 0,5 Н.м.
16. If the moment appears less demanded slightly tighten a reducer nut until then the necessary moment will not be reached yet.
17. If the moment appears more limiting it is necessary to disassemble a reducer and to replace распорную the plug of bearings of a leading shaft of a reducer (is carried out in car-care centre).
The prevention

It is forbidden to turn on a nut to weaken a tightness in bearings.
18. Further assemblage is carried out upside-down.
19. Attach карданный a shaft, сориентировав on labels, fill in oil.