Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. A mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. A distributing box
   - 7.4. Coupling, карданные shaft, semiaxes and leading bridges
      7.4.1. Technical characteristics
      + 7.4.2. Coupling
      + 7.4.3. Карданный () a shaft (), a reducer and axes
      7.4.4. A lobby полуось and an epiploon
      - 7.4.5. The back (forward) bridge
         7.4.5.1. A reducer epiploon
         7.4.5.2. Полуось, the bearing and an epiploon (semiunloading semiaxes)
         7.4.5.3. Полуось and an epiploon (completely unloaded semiaxes)
         7.4.5.4. A nave of a back wheel (completely unloaded semiaxes)
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


122d58df

7.4.5. The back (forward) bridge

Removal and installation

PERFORMANCE ORDER
1. Lift the car and establish on supports under a body.
2. Remove wheels.
3. Remove brake details.
4. On a forward axis disconnect steering draughts.
5. Disconnect from a bridge reducer карданный a shaft.
6. Disconnect the stabilizer of cross-section stability (if it is provided).
7. Disconnect from the bridge a cross-section bar (if it is provided).
8. Deduce a cable of a manual brake from assembly скоб the back bridge, remove cable arms (subsection 8.14 see).
9. Disconnect a socket from the gauge of speed (on cars with ABS-system).
10. Disconnect and muffle hoses and tubes of a hydrodrive of brakes.
11. Disconnect from the back bridge the loading gauge (if it is provided).
12. Slightly will hang out the bridge, having substituted under it 2 jacks.
13. Disconnect shock-absorbers.
14. Remove springs (if are provided, subsection 9.5 see).
15. On cars with springs turn away bolts of step-ladders of springs and remove fastening plates.
16. Turn away bolts of levers of springs and remove springs.

The prevention

After a detachment of springs the bridge becomes loose. Ask the assistant to support the bridge on jacks.


17. On the cars equipped with springs of a back suspension bracket, disconnect from the bridge the bottom levers (keep in mind that after that the bridge becomes loose).
18. Cautiously lower the bridge and roll out from under the car.
19. Bridge installation is carried out upside-down.
20. Tighten all fastenings with the set moments.