Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation


Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS-system
   8.3. Колодки disk brakes (forward or back)
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. Removal of air from a hydrodrive of brakes
   8.11. The vacuum amplifier of brakes
   8.12. Колодки a manual brake of back disk brakes
   8.13. Adjustment of a manual brake
   8.14. A cable of a manual brake
   8.15. The switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and перепускной the valve)
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


122d58df

8.7. The wheel cylinder of brakes
THE GENERAL DATA

Details of the wheel cylinder of brakes with a horizontal arrangement колодок

Details of the wheel cylinder of brakes with a vertical arrangement колодок

 1. A cap

2. The union for prorolling

3. A cover

4. The piston

5. A cuff

6. A spring

7. The cylinder

The scheme of installation of cylinders on brakes with a horizontal arrangement колодок
1. The left wheel
2. The right wheel
 3. The left carving
4. The right carving
The prevention

At leak detection replace the cylinder. Cylinders vary only in steam on an axis.

Removal

PERFORMANCE ORDER
1. Lift the car.
2. Remove Pads.
3. Clear the wheel cylinder.
4. Turn away the union () a hydrodrive and bolts (), a tube not to disconnect.
5. Turn away bolts of fastening of the cylinder.
6. Remove the cylinder and muffle tubes.

Dismantling

PERFORMANCE ORDER
1. Turn out the union for prorolling, remove dustproof covers, get pistons with cuffs and springs.
2. Wash out details spirit or a brake liquid.
3. Dry and blow cylinder channels.
4. Check up a condition of a surface of the cylinder. At detection of strong damages (scratches) replace the cylinder.
5. Grease new cuffs with a brake liquid.
6. Establish cuffs on pistons so that edges of cuffs have been turned in the cylinder.
7. Collect the cylinder.
8. Establish the cylinder, wrap bolts by hand. Wrap the union and tighten fastening bolts (the Scheme of installation of cylinders fig. see brakes with a horizontal arrangement колодок).
9. Tighten the union and establish Pads.
10. Remove air from a hydrodrive.
11. Check up work of brakes.