Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS-system
   8.3. Колодки disk brakes (forward or back)
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. Removal of air from a hydrodrive of brakes
   8.11. The vacuum amplifier of brakes
   8.12. Колодки a manual brake of back disk brakes
   8.13. Adjustment of a manual brake
   8.14. A cable of a manual brake
   8.15. The switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and перепускной the valve)
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

8.12. Колодки a manual brake of back disk brakes
Check and replacement

PERFORMANCE ORDER

1. Remove a brake disk.

2. Clear the mechanism of a manual brake.

3. Check up a residual thickness of frictional overlays. Replace Pads, if a thickness of a material less than 1,0 mm.

4. Remove springs of a manual brake.

5. Remove распорку колодок.

6. Remove a clamping spring back Pads.

7. Remove back колодку and a regulator.

8. Remove a clamping spring of a lobby Pads, disconnect a cable from the lever and remove колодку.

9. Remove a screw-driver a lock washer from an axis of the lever of a manual brake, remove the lever, a lining and an axis.

10. Rearrange these details on new колодку and press out a washer.

11. Grease with a thin layer of refractory greasing a rubbing surface of a board of a brake and a carving.

12. Grease with a thin layer of refractory greasing a sliding surface of a regulator in the specified places.

13. Attach a cable to the lever and establish a lobby колодку.

14. Fix колодку a spring.

15. Put on the bottom spring and establish a regulator.

16. Establish back колодку.

17. Fix колодку a spring.

18. Put on on back колодку the top spring.

19. Establish распорку so that the spring has been turned forward.

20. Establish returnable springs колодок.

21. Establish a disk of a brake and fix, having screwed nuts of wheels.

22. Remove from a disk заглушку.

23. Adjust Pads for what, rotating a cogwheel of a hairpin of a regulator, dissolve Pads against the stop in a drum (the drum thus should not rotate) and take away, having turned away a hairpin on 8 teeth.

24. Establish a support arm, tighten bolts with the set moment.

25. Establish a wheel.

26. Check up number of clicks of the lever of a manual brake before full braking which should be equal 5. Otherwise adjust (subsection 8.13) see.

27. For extra earnings колодок brakes arrive as follows.

28. Moving with a speed of 50 km/hour on equal dry highway, include a brake, having made the lever effort 8кГс and pass about 0,5 km then release the lever.

29. Repeat this procedure 2–3 times, allowing to cool down preliminary колодкам.