Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
- 5. Fuel and exhaust systems
   + 5.1. Carburettor engines
   - 5.2. Engines with fuel injection
      5.2.1. Technical characteristics
      5.2.2. Декомпрессия fuel system
      + 5.2.3. The fuel pump and pressure of fuel
      5.2.4. Gasoline pipe lines and joints
      5.2.5. The fuel pump
      5.2.6. The gauge of level of fuel
      5.2.7. The air filter
      5.2.8. A cable of a drive throttle заслонки
      - 5.2.9. System of electronic injection of fuel (EFI-system)
         5.2.9.1. Check of system of electronic injection of fuel
         - 5.2.9.2. Units of system of electronic injection of fuel
            5.2.9.2.1. The case throttle заслонки
            5.2.9.2.2. The gauge of an angle of rotation throttle заслонки
            5.2.9.2.3. A regulator of pressure of fuel
            5.2.9.2.4. The valve of a regulator of turns of idling
            5.2.9.2.5. The fuel and atomizer distributor
            5.2.9.2.6. The levelling chamber
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

5.2.9.2.6. The levelling chamber Removal

PERFORMANCE ORDER

The prevention
Works are carried out on the cold engine.

1. Disconnect the battery from weight.

2. Disconnect from the chamber all sockets.

3. Disconnect a drive cable заслонки and draught of transmission.

4. Remove a branch pipe arm маслоуказателя.

5. Accurately designate and disconnect all vacuum hoses.

6. Disconnect a hose of system of ventilation картера.

7. Turn away a bolt and remove an arm (if it is provided).

8. Disconnect and muffle hoses of a cooling liquid.

9. Turn away bolts and remove the chamber.

Installation

PERFORMANCE ORDER

1. Clear and check up a condition of demountable planes of a collector and the chamber. Replace a lining of the bottom inlet collector. Establish on an inlet collector the chamber in gathering with the case заслонки. Be convinced of correctness of installation of a lining.

2. Wrap fastening bolts to an inlet collector, tighten bolts with the moment specified in (subsection 3.2.1 see). Further installation is carried out upside-down.