Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation

Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
- 11. An electric equipment
   11.1. Search of malfunctions
   11.2. Safety locks
   11.3. Fusible crosspieces
   11.4. Breakers
   11.5. The relay
   11.6. The breaker of indexes of turn / of the alarm system
   11.7. A combination of switches on a steering column
   11.8. The lock of ignition and a lock drum
   11.9. Indexes of level of fuel, pressure and oil temperature
   11.10. A guard of devices
   11.11. The screen wiper electric motor
   11.12. The receiver and dynamics
   11.13. The aerial
   11.14. A heater of back glass
   11.15. Headlights
   11.16. The case галогенной headlights
   11.17. A sound signal
   11.18. Replacement of lamps
   11.19. Lateral mirrors with the electric drive
   11.20. Cruise-control system
   11.21. The electric drive window lifterа
   11.22. The electric drive of door-locks
   11.23. Safety pillows
+ 12. Electroschemes

11.2. Safety locks

THE GENERAL DATA

Chains of an electric equipment of the car are protected by safety locks, breakers or fusible crosspieces.

The assembly block of safety locks is mounted in salon or in a motor compartment, depending on year of release and car model.

The block of safety locks on cars FJ80

The block of safety locks is mounted under the forward facing panel and closed by a cover (on cars FJ60 and 62 arrangement is similar).

The block of safety locks and the relay in a motor compartment on cars FJ80

A.Predohraniteli

V.Plavkie inserts

S.Rele

On a cover of the assembly block the chain which protects the given safety lock is specified. At chain refusal first of all check up a safety lock. Safety locks are established on contacts ножевого type and get by hand. The fused safety lock is easily found out on appearance.

Appearance of safety locks

At the left – the fused safety lock.

On the right – a serviceable safety lock.

It is possible to check up also pressure on conclusions. The safety lock has fused if the voltmeter shows pressure. To replace a safety lock get faulty and insert new, having pushed it into a nest.

The rated current of a new safety lock should correspond in accuracy to a current of the replaced. The rated current is specified on a safety lock. It is forbidden to use wire pieces instead of a safety lock. If the new safety lock immediately fuses, find the reason and eliminate. As a rule blowing it is caused by short circuit of wires because of their retyranny.