Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
- 10. A body
   10.1. Maintenance service and repair
   10.2. Vinyl furnish
   10.3. An upholstery and rugs
   10.4. Repair of insignificant damages
   10.5. Repair of considerable damages
   10.6. Loops and locks
   10.7. A windscreen and motionless glasses
   10.8. A cowl
   10.9. A latch of a cowl and a drive cable
   10.10. A forward lattice
   10.11. A forward wing
   10.12. The internal panel of a door
   10.13. The door lock, the lock and handle switch
   10.14. Door glass
   10.15. Стеклоподъемник
   10.16. Lateral mirrors
   10.17. A door
   10.18. A door of a back compartment
   10.19. A back cover (the top door of a back compartment)
   10.20. A casing of a steering column
   10.21. Panels of forward facing of salon
   10.22. Average floor section
   10.23. The forward facing panel of salon
   10.24. Seats
   10.25. Bumpers
+ 11. An electric equipment
+ 12. Electroschemes


122d58df

10.9. A latch of a cowl and a drive cable Removal and installation

LATCH

PERFORMANCE ORDER
1. Outline a contour of a latch and turn away fastening bolts to a cross-beam передка. Remove a latch.
2. Disconnect from a latch a cable.
3. Installation is carried out upside-down.

DRIVE CABLE

PERFORMANCE ORDER
1. Disconnect a cable of a drive of a latch.
2. Attach to a cable a piece of a strong wire and following on a line of packing of a cable, disconnect latches, fastening a cable cover to a body.
3. In salon turn away fastening screws (are specified by arrows) handles of a cable of a drive of a latch of a cowl.
4. Get a cable, having extended it together with a sealant in salon until then yet the wire will not seem. Remove an old cable and attach to a wire a new cable together with a sealant.
5. Stretch a cable in a motor compartment, undertaken a wire.
6. Installation is carried out upside-down. Establish a through sealant, having pressed on it fingers so that it has come into an aperture of a partition of a motor compartment.