Toyota Land Cruiser
FJ60, FJ62 and FJ80 1980-1997 of release
Repair and car operation
Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
- 10. A body
10.1. Maintenance service and repair
10.2. Vinyl furnish
10.3. An upholstery and rugs
10.4. Repair of insignificant damages
10.5. Repair of considerable damages
10.6. Loops and locks
10.7. A windscreen and motionless glasses
10.8. A cowl
10.9. A latch of a cowl and a drive cable
10.10. A forward lattice
10.11. A forward wing
10.12. The internal panel of a door
10.13. The door lock, the lock and handle switch
10.14. Door glass
10.16. Lateral mirrors
10.17. A door
10.18. A door of a back compartment
10.19. A back cover (the top door of a back compartment)
10.20. A casing of a steering column
10.21. Panels of forward facing of salon
10.22. Average floor section
10.23. The forward facing panel of salon
+ 11. An electric equipment
+ 12. Electroschemes
The condition in which there is a body of your car, is very important, because its cost depends on it in the big degree at resale. It is much more difficult to repair the started or damaged body, than mechanical parts. The latent cavities of a body, such as niches of wheels, a frame and a motor compartment also are important not less in spite of the fact that they do not demand frequent attention, as other parts of a body.
Once a year, or each 20 000 km, the bottom of a body by means of steam is very useful to clear. All traces of a dirt and oil will be removed, and after this area it will be possible to check up on presence of the rust, the damaged brake highways, the worn out electric wires, the damaged ropes and so on. In the end of this work it is necessary to grease components of a forward suspension bracket.
Simultaneously clear the engine and a motor compartment with the help пароочистителя or adaptations for greasing removal.
The special attention is necessary for turning on niches of wheels as the substrate can exfoliate, both stones and a dirt, thrown out by wheels, can damage a paint and allow to appear to a rust. If you have found out a rust, smooth out the damaged surface to the metal and put on it an anticorrosive paint.
Tar or bitumen stains are necessary for clearing by means of a fabric moistened in solvent.
At least, each six months polish a body and the chromeplated details. If you use a cleaner for the chromeplated parts to remove a rust from details with гальванопокрытием, remember that the cleaner also deletes honour of chrome so use it cautiously.