Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
- 10. A body
   10.1. Maintenance service and repair
   10.2. Vinyl furnish
   10.3. An upholstery and rugs
   10.4. Repair of insignificant damages
   10.5. Repair of considerable damages
   10.6. Loops and locks
   10.7. A windscreen and motionless glasses
   10.8. A cowl
   10.9. A latch of a cowl and a drive cable
   10.10. A forward lattice
   10.11. A forward wing
   10.12. The internal panel of a door
   10.13. The door lock, the lock and handle switch
   10.14. Door glass
   10.15. Стеклоподъемник
   10.16. Lateral mirrors
   10.17. A door
   10.18. A door of a back compartment
   10.19. A back cover (the top door of a back compartment)
   10.20. A casing of a steering column
   10.21. Panels of forward facing of salon
   10.22. Average floor section
   10.23. The forward facing panel of salon
   10.24. Seats
   10.25. Bumpers
+ 11. An electric equipment
+ 12. Electroschemes



10.8. A cowl
THE GENERAL DATA

The prevention

Works are carried out together.


Removal and installation

PERFORMANCE ORDER
1. Open a cowl and close rags wings and an air inlet lattice.
2. Outline contours of loops of a cowl.
3. Disconnect all hoses and wires which can prevent cowl removal.
4. Lift a cowl and ask the assistant to keep it. Remove a rack of a cowl and turn away a nut (or bolts) fastenings of loops.
5. Remove a cowl.
6. Installation is carried out upside-down.

Adjustment

PERFORMANCE ORDER
1. Cowl position is across regulated by its moving to cuts of loops at the released bolts.
2. Outline contours of loops.
3. Release bolts and move a cowl to the necessary position then bolts tighten. Move a cowl gradually, periodically checking adjustment.
4. After installation it is necessary to adjust latch position on a vertical and across so that the cowl was densely closed, and the cowl surface was заподлицо with wings. Outline bolts of a latch of a clamp of a cowl, release bolts (are specified by arrows) and adjust latch position. Tighten bolts.
5. A cowl and loop latch periodically grease литолом.








Запчасти для электроинструмента http://aziatool.com