Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and car operation



Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS-system
   8.3. Колодки disk brakes (forward or back)
   8.4. A brake support
   8.5. A brake disk
   8.6. Колодки drum-type brakes
   8.7. The wheel cylinder of brakes
   8.8. The main cylinder of brakes
   8.9. Hoses and hydrodrive tubes
   8.10. Removal of air from a hydrodrive of brakes
   8.11. The vacuum amplifier of brakes
   8.12. Колодки a manual brake of back disk brakes
   8.13. Adjustment of a manual brake
   8.14. A cable of a manual brake
   8.15. The switch of a signal of braking
   8.16. A regulator of pressure of back brakes (dosing out and перепускной the valve)
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes


122d58df

8.10. Removal of air from a hydrodrive of brakes
THE GENERAL DATA

Necessity of prorolling arises after a detachment of tubes of the main cylinder or at strong fall of level in a tank.

At dismantling of a hydrodrive of one wheel it is possible to be limited to air removal only from the understanding cylinder.

If the highway from the main cylinder to wheel it is possible to be limited to air removal only from this highway understood.
PERFORMANCE ORDER
1. Press some times a pedal of a brake and remove residual depression in the amplifier.
2. Before prorolling restore liquid level in a tank and during prorolling support level, without supposing a tank devastation. Fill in only a fresh liquid.
3. Prepare a liquid, a vessel, a hose for prorolling and a key for отворачивания the union.
4. Prorolling begin with a back right wheel.
5. Attach to the union a hose, other end of a hose lower in a vessel with a brake liquid.
6. Ask the assistant to press slowly some times a pedal of a brake and to keep.
7. Turn away the union, and later 2 сек after a stream of a liquid following with bubbles ослабнет, tighten the union. Ask the assistant to release a pedal.
8. Repeat procedure until in a following liquid air vials will not cease to be observed.
9. Tighten the union.
10. Execute these actions in sequence: the left back wheel, the right forward, left forward.
11. Upon termination of prorolling restore liquid level in a tank.
12. Remove air from a pressure regulator (dosing out and перепускного valves), having repeated specified above action (1 – the union for prorolling).
13. Check up rigidity of a pedal and work of brakes.
14. If necessary repeat procedure.