Toyota Land Cruiser
FJ60, FJ62 and FJ80 1980-1997 of release
Repair and car operation
Toyota Land Cruiser
+ 1. The maintenance instruction
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engines 2F and 3F-E
+ 3.2. The verhneklapannyj engine 1FZ-FE
+ 3.3. Dismantle and engine major repairs
- 3.4. An engine electric equipment
3.4.1. Technical characteristics
3.4.2. The battery
3.4.3. Power cables
- 3.4.4. Ignition system
126.96.36.199. Check of system of ignition
3.4.5. The ignition coil
3.4.6. The ignition distributor
3.4.7. The block of electronic ignition
3.4.8. The induction gauge
+ 3.4.9. System of a charge of the battery
3.4.10. The generator
3.4.11. Generator details
3.4.12. System of start-up of the engine
3.4.13. The starter electric motor
3.4.14. The traction relay of a starter (а/м 1980-87 of release)
+ 4. Systems of cooling, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and a steering
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes
3.4.4. Ignition system
The scheme of ignition of cars 1980-87
The scheme of ignition of cars 1988-92
The scheme of ignition of cars of 1993
The system of electronic ignition includes the ignition lock, the battery, the block of electronic ignition, the Hall gauge (1980-87) or the induction gauge (with 1988г.), the coil of ignition, a wire of a low-voltage (primary) chain and a high-voltage (secondary) chain, the ignition and candle distributor.
On considered cars the ignition coil is mounted separately from the distributor.
Cars are equipped 1980-87 centrifugal and vacuum by regulators of an advancing of ignition. The electronic switchboard of ignition is mounted on the coil case. The gauge of signals on effect of the Hall is built in the distributor on a breaker plate with which the rod of a vacuum regulator (see fig. the Scheme of ignition of cars 1980-87) is rigidly connected.
Cars are equipped 1988-92 by automatic system of an advancing of ignition ESA on the basis of the induction gauge (fig. the Scheme of ignition of cars see 1988-92). The electronic switchboard of ignition is mounted on the coil case.
The system of ignition of cars since 1993 is similar to system of cars 1988-92 behind that exception that in the induction gauge the additional winding with pair conclusions G1 and G2 (fig. the Scheme of ignition of cars of 1993 see) is provided.
At performance of checks and repair of system of ignition it is necessary to observe following safety rules (except specified above).
Connect a tachometre according to the instruction of the manufacturer. Tachometres of some types are incompatible with system of an electric equipment of the car. Before tachometre acquisition consult in car-care centre.
Do not suppose a contact of conclusions of the coil of ignition with weight. Otherwise failure of the electronic block and the coil is possible.
Constantly watch that the electronic block has been reliably connected to weight.